LENCO DAR-045 Mode D'emploi page 9

Manual Scan
1. Turn on the unit in DAB+ mode.
2. Press the MENU button to access the menu control.
3. Press the PREVIOUS
4. Press the PREVIOUS
5. Press the ENTER button to confirm.
6. To select another channel (5A-13F), press the PREVIOUS
7. When the station is found, press the ENTER button to select.
8. To quit manual scan, press the MENU button.
Tuning
Press the TUNE or TUNE
station within a few seconds.
Storing DAB+ Presets
You can save up to 20 DAB+ stations.
1. Tune to the station you wish to store.
2. Press and hold the MEM/PROG button. Display icon "PROG" will flash.
3. Press the PREVIOUS
Recall Stored DAB+ Presets
Press the CH- or CH+ button directly tune to the preset channel.
Or press the [MEM/PROG] button once. Preset channel number is displayed. Then press the PREVIOUS
preset number that you want to recall and press the ENTER button to confirm.
Or to directly recall the preset channel by using the numeric buttons, press the numeric buttons [1], [2], ..., [0]. For example when the
button [3] is pressed and then follow by pressing the ENTER button, it will tune to preset channel 3. Or when the button [1] and then
button [2] are pressed and then follow by pressing the ENTER button, it will tune to preset channel 12.
Displaying DAB+ Station Information
There are several types of information as listed below. To change the display information, press the INFO button repeatedly.
1. Radio Text scrolling
Shows music titles or program details provided by the broadcaster.
2. Signal Bar
Transmission signal level. The more characters are displayed, the stronger the signal being received. To improve the reception
adjust the antenna position.
3. Program Type (PTY)
Type of program provided by the broadcaster.
4. Multiplex Name
Displays name of multiplex to which the current station belongs.
5. Frequency
Current channel frequency.
6. Signal Error Rate
Shows the error rate. The larger this value, the more errors it receives. To improve the reception, adjust the antenna position.
7. Audio Bit Rate
This is the current channel audio Bitrate.
8. Time
Displays the time provided by the radio station.
9. Date
Displays the current date provided by the radio station.
OTHER DAB+ MENU OPERATION
Press the MENU button to access the menu control. Then press the PREVIOUS
described below.
Dynamic Range Control (DRC)
DRC can make quieter sounds easier to hear when the unit is used in a noisy environment. The DRC level of a broadcast is set by the
broadcaster and transmitted with the service. Changing the DRC value on your unit enables you to apply a scaling factor to this level.
There are three levels of compression:
DRC HIGH:
DRC LOW:
DRC OFF:
or NEXT button until "Manual tune" is displayed and then press the ENTER button.
or NEXT button to select the desired channel (5A-13F).
button to display the information of the next station. Then press the ENTER button to tune to this
or NEXT button to the preset number that you want to store. Then press the ENTER button to save.
Maximum compression as sent with the transmitted service
Set to 1/2 that of the sent transmitted service
No compression
or NEXT button and then press the ENTER button to confirm.
or NEXT
9
or NEXT button to the
button for different options as