Assembly - Arctic Cove MODF001 Manuel D'utilisation

UNPACKING
This product requires assembly:
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
 If any parts are damaged or missing, please call
1-877-297-8911 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
TOOLS NEEDED
Small phillips head screw driver, small wrench

ASSEMBLY

ASSEMBLING THE STAND AND MOTOR HEAD
See Figures 4 - 7.
 Turn the base lock counterclockwise to remove the base
lock and washer from the lower stand assembly.
 Turn the base upside down.
 Place the weight and washer (dome side down) inside
the base as shown in figure 5.
 Insert base lock through the washer, weight, and base
then hold base lock in place and place the lower pole into
the base.
 Secure pole to the base by turning the base lock
clockwise (see figure 6).
ASSEMBLING THE MOTOR HEAD, FAN, AND
FAN COVERS
See Figures 8 - 13.
 Remove lock knob on top end of the stand assembly, set
aside.
 Align the hole in the top of the upper pole with the hole in
the motor head. Install lock knob into holes and tighten
securely (see figure 7).
 Unscrew and set aside the four screws and the nose
guard from the motor head (see figure 8).
 Attach the rear fan cover on the motor head.
NOTE: The screw hole in the rear fan cover must be at
the bottom with Arctic Cove logo at the top. (see figure 9).
 Reinstall the four screws and tighten securely.
 Place the fan blade on the spindle of the motor head and
align the pin in the spindle with the slot in the fan blade.
Use the nose guard to secure the fan in place as shown
in figure 10.
 Remove the small screw and nut from the bottom of the
front fan cover. Carefully set aside.
 Lift the lock levers and slide the hook at the top of the
front fan cover over the rear fan cover. Line up screw
holes at bottom of fan covers.
NOTE: The prongs on the hook must slide over the top
wire on the rear fan cover as shown in figure 11.
 Push all the lock levers down to lock the front and rear
fan covers together.
 Reinstall the screw and hex nut as shown in figure 12.
Tighten securely.
5 — English