Denon DCM-380 Mode D'emploi page 14

ENGLISH
t
To Play the Desired Discs and
the Desired Tracks in the
Desired Order ..................................................................
• You can play certain tracks on the loaded discs in any order.
• Tracks on a disc not loaded can also be programmed, but if you try
to play that disc, the microprocessor detects that it is not loaded
and the following disc is played automatically.
• Up to 32 tracks can be set in a program.
(1) Programming (Remote control only)
• Press the PROG/DIRECT button. The "PROGRAM" indicator lights.
Use the DISC SELECT button, number and +10 buttons to select
the disc to be programmed.
For example, to program the 3rd track on the 2nd disc and the 12
track on the 5th disc, press
DISC SELECT , 5 , +10
(2) To Check the Programmed Tracks (Remote control only)
• Press the CALL button on the wireless remote control unit.
The contents of the program are displayed in order one item at a
time each time the CALL button is pressed.
14
Program Selection
1
(PROG / DIRECT)
2
(DISC SELECT)
4
(1 ~ 10)
3
(1 ~ 5)
PROG/DIRECT , DISC SELECT
and 2 .
(CALL)
(3) To Play a Program
(1 PLAY)
• Press the 1 PLAY button to play the programmed selections in the
order in which they were programmed.
(4) To clear the entire program
• Pressing the PROG/DIRECT button once more erases the entire
program. Pressing the 5 OPEN/CLOSE button also erases the
contents of a program.
• Pressing the PROG/DIRECT button while a program is being played
cancels the program. Play will then be continuous to the end of the
disc currently being played, after which the player will stop
automatically.
, 2 , 3 ,
Cautions:
• Programmed playback is not possible with MP3 discs.
If an MP3 disc is specified, that step in the program is ignored.
• If a program is run during playing of a track or from the Pause state,
the track which is currently being played becomes the 1st track in
the program.
• Direct selection cannot be done while a program is being played.
Inputting the track number of a desired track with the Track Number
buttons adds the input track to the end of the program.
• When programming, do not program a track number which is not
recorded on the disc. If such a number is programmed by mistake,
the player ignore the program.
(1 PLAY)