Changing Parameters; Opening Service Parameters; Parameterisation Using Remote Control - FEIG Electronic MWD BP-C Mode D'emploi

8.3 Changing parameters

Before changing parameter values you have to open the parameter entry as described in chapter 8.1.
Key
1. Right
2. Left
3. Right
4a. Left
or
4b. Left
5. Left

8.4 Opening service parameters

To display the Service Parameter you have first to open the parameter entry as described in chapter 8.1.
Service Parameter names are displayed with flashing character and static decimal point.
Menu navigation is conform to the navigation of standard parameter.
Button
1. Left and Right
9

Parameterisation using remote control

When starting parameter mode, the channel to be edited or parameterised must first be selected.
The numeric address of the first channel is displayed flashing when parameter mode is started. The following
number is automatically assigned to channel 2.
The channel for editing is opened by confirming the device address.
The value "1" is usually displayed for channel 1. If 1 is now input, channel 1 is processed and if 2 is input,
then channel 2 is processed.
FEIG ELECTRONIC GmbH
Manual
Key-
Description
press
short
Change parameter name
(long: quick selection)
(long)
Return to display
short
actual parameter value
short
Change parameter value
(long: quick selection)
(long)
short
Undo changes
long
Save new parameter value
Return to display
short
parameter name
Key-
Description
press
Activate service parameter from
long
standard parameter menu
Page 36 of 103
Action
Display parameter name with
character and decimal point.
Actual parameter value is
displayed without decimal point.
Display changed parameter value
with blinking decimal point.
Display actual parameter value
again (without decimal point).
Decimal point expires after
successful saving.
Display parameter name with
character and decimal point.
Action
Display first service parameter
name
MWD BP_Handbuch_mehrsprachig_12.doc
MWD BP
Display
Example
d.
1
2.
1
2
d.
Display
Example
A.