Trouble Shooting - Danby Silhouette SELECT DBC7070BLSST Manuel Du Propriétaire

Occasionally, a problem is minor and a service call may not be necessary - use this trouble shooting
guide for a possible solution. If the unit continues to operate improperly, call an authorized service
depot or Danby's Toll Free Number 1-800-263-2629.
Problem
No Power.
Cabinet Temperature
too High
Condensation on the
cabinet and/or doors

Trouble Shooting

Possible Cause What to do
A fuse in your home may
be blown or the circuit
breaker tripped
Power surge
Plug not fully inserted into
wall outlet
Temperature setting
Door(s) not shut properly
or opened excessively
Exhaust vent is obstructed
Recently added a large
quantity of warm bottles
to the cabinet
High humidity conditions
in the home
Door(s) not shut properly
or opened excessively
11
Replace fuse or reset circuit breaker.
Unplug the Beverage Center, wait a few
seconds and then plug it back in
Make sure the 3-prong plug on the
Beverage Center is fully inserted into outlet
Verify the temperature control setting
Adjust if neccessary
Ensure that the doors are fully closed
and that the gaskets are sealing
against the cabinet. Open the doors
only as needed and for short periods
of time
Verify there is nothing blocking the
front mounted exhausting vent
Limit the quantity of warm bottles
being introduced to the cabinet.
The condensation will subside once
humidity conditions return to normal
Ensure that the doors are fully closed
and that the gaskets are sealing
against the cabinets. Open the doors
only as needed and for short periods
of time