Trouble Shooting - Danby Silhouette DBC056D1BSSPR Manuel Du Propriétaire

Occasionally, a problem is minor and a service call may not be necessary - use this trouble
shooting guide for a possible solution. If the unit continues to operate improperly, call an
authorized service depot or toll free at 1-844-455-6097
Problem
No Power
Cabinet Temperature
too High
Alarm beeping and
"HI" is displayed on
the control panel
Alarm beeping and
"LO" is displayed in
the control panel
Condensation on the High humidity conditions
cabinet and/or doors in the home

Trouble Shooting

Possible Cause
A fuse in your home may be
blown or the circuit breaker
tripped
Power surge
Plug not fully inserted into
wall outlet
Temperature setting
Door not shut properly
or opened excessively
Exhaust vent is obstructed
Recently added a large
quantity of warm beverages
to the cabinet
Recently added a large
quantity of warm bottles or
cant to the cabinet
The door is not closed tightly
System leak, Evaporator fan
failure, compressor fan failure
Sensor failure, Evaporator
temperature too low
Door not shut properly
or opened excessively
11
What to do
Replace fuse or reset circuit breaker
Unplug the beverage center, wait a few
seconds and then plug it back in
Make sure the 3-prong plug is fully
inserted into outlet
Verify the temperature control setting
Adjust if neccessary
Ensure that the door is fully closed
and that the gasket is sealing against
the cabinet. Open the doors only as
needed and for short periods of time
Verify there is nothing blocking the
front mounted exhausting vent
Limit the quantity of warm beverages
being introduced to the cabinet at the
same time. Attempt to stagger the
load introduction if possible
Limit the quantity of warm items being
introduced to the cabinet
Be sure the door is closed tightly
Contact service center.
To stop beeping, unplug the unit.
Contact service center.
To stop beeping, unplug the unit
The condensation will subside once
humidity conditions return to normal
Ensure that the door is fully closed
and that the gasket is sealing against
the cabinet. Open the door only as
needed and for short periods of time