Bluetooth ® Pairing - Hama TUBE Mode D'emploi

• Connect the unused connector on the
Micro-USB charging cable to a suitable
USB charger. Please refer to the operating
instructions for the USB charger used.
• The status LED (9) lights up constantly in red
during the charging process.
• If the battery is fully charged, the status LED
(9) will go out.
Note – Charging
• It takes approx. 2 hours to completely
charge the product.
• The speaker's battery can be charged
whether the speaker is on or off.
• If the battery capacity is less than 10%,
the speaker will emit two acoustic
signals. You will only receive this
information if the speaker is on.
• The actual battery life varies depending
on use of the device, the settings and the
ambient conditions (rechargeable batteries
have a limited service life).
4
4.3 Bluetooth
pairing
®
Note
• Check whether your mobile device (MP3
player, mobile phone, etc.) is Bluetooth
capable.
• Note that the maximum range for
Bluetooth
is 10 metres without
®
obstacles such as walls, people, etc.
• Make sure that your Bluetooth
terminal device is on and Bluetooth
is activated.
• Make sure that the speaker is located
within the Bluetooth
10 metres.
• Switch on the speakers as described in
4.1 Switching the product on and off.
• The status LED (9) begins to ash. The
speaker searches for a connection.
• Open the Bluetooth
terminal device and wait until Hama
Tube appears in the list of Bluetooth
devices found.
• Select Hama Tube and wait until the
speaker is listed as connected in the
Bluetooth
settings on your terminal device.
®
An acoustic signal con rms that connection
was successful.
• The status LED (9) now remains red.
capable
®
®
range of max.
®
settings on your
®
®
®