Disposal And Recycling; Regulations; Technical Data; Eu Declaration Of Conformity - stayer HP750BE Instructions D'emploi

equipment, you should find the warranty card. You should
fill out the card completely and retum to vendar with a copy
of purchasing receipt or invoice and you should receive a
receipt.
Note: lf you cannot find the warranty card within
the documentation,youmust ask for it through your
supplier.
The warranty is limited only to manufacturing defects and
expire if pieces have been removed or manipulated or
repaired otherthan themanufacturer.

5.4 Disposal and recycling

The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
OnlyforEC countries:
Do not dispose of power tools into household waste!
According the European Guideline 2002/96/
EC for Waste Electrical and Electronic
Equipment and its implementation into national
right,power tools that are no longer usable
must be collected separately and disposed of
in an environmentally correct manner.
Subject to change wlthout notlce.

6. Regulations

6.1 Technical Data

= Rated power input
= Load speed
= Disc Diameter
= Weight
L = Sound power level
WA
L = Sound pressure level
PA
= Vibration
The values givenarevalid for nominalvoltages [U]230/240
V-50/60 Hz - 110/120 V - 60Hz. For lower voltage and
models for specific countries, these values can vary.
Please observe the article number on the type plata of
your machine.The trade names of the individual machines
may vary.
NoiseNibration lnformation
Noise determined according to EN 60745.
The typical sound pressure level of appliance determined
with a filter A product are: Sound pressure level 88 dB(A);
sound power level 99 dB(A). Tolerance K=3 dB.
Wear hearing protection!
Total vibration values (vector sum of three directions)
determined according to EN 60745: Sanding drywal
a =4 m/s , K= 1,5 m/s .
h 2 2
ENGLISH
13
The vibration emission level given in this information sheet
has been measured in accordance with a standardised
test given in EN 60745 and may be used to compare
one tool with another. lt may be used for a preliminary
assessment of exposure.
The declared vibration emission level represents the
main applications of the tool. However if the tool is used
for different applications,with different accessories or
poorly maintained, the vibration emission may differ.
This may significantly increase the exposure leveloverthe
totalworking period.
An estimation of the levelof exposure to vibration should
also take into account the times when the tool is switched
off or when it is running but not actually doing the job. This
may significantly reduce theexposure level over the total
working period.
ldentify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool
and the accessories,keepthe hands warm, organisation of
work pattems.

6.2 EU declaration of conformity

The undersigned: STAYER IBERICA, S.A.
With address at:
Calle Sierra de Cazorla, 7
Área Empresarial Andalucía - Sector 1
28320 PINTO (MADRID)
Tel.:+34 91 691 85 16 / Fax: +34 91 691 91 72
CERTIFIES
That the machine:
HAND WALL SANDER
Type:
Models: HP750BE
I declare under our responsibility that the product
described under "Technical Data" is in accordance with
the following standards or standardized documents:
EN60745-1, EN60745-2-3, EN55014-1, EN55014-2,
EN61000-3-2, EN61000-3-3, according to regulations
2006/42/CE, 2014/30/EU.
Ramiro de la fuente
Managing Director
13
January, 2019