Repair Service; Disposal And Recycling; Declaration Of Conformity - stayer LH187C Instructions D'emploi

Tool change
Carbon brushes
- In case of excessive sparking, have the carbon brushes
checked only by a qualified electrician. Important! The
carbon brushes should not be remplaced by anyone
but a qualified electrician.
Cleaning, maintenance and ordering of spare parts
Always pull out the mains power plug before starting any
cleaning work.
Only LH190E (Fig. 11)
Remove the lid 11 of the collector box 6 and both the filter
and shake dust box for cleaning. Figure 11
Regularly clean the ventilation slots.
Do not use abrasive cleaners on the plastic housing.
Keep openings free of dust extraction
dirt or other obstructions.
Water must never come into contact with the filter. You can
use compressed air. Blow first from the inside.
Cleaning
- Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with
compressed air at low pressure.
- We recommend that you clean the tool immediately
after you use it.
- Clean the equipment regularly with a moist cloth and
some soft soap. Do not use cleaning agents or solvents;
these may be aggressive to the tool's plastic parts.
Ensure that no water can get into the interior of the tool.

Repair service

The technical service will provide you advice regarding
questions you may have on the repair and maintenance of
your product as well as on spare parts.
You may also obtain exploded views and information on
spare parts on the internet under:
info@grupostayer.com

Disposal and recycling

The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According the European Guideline 2002/96/EC
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
correct manner.
Subject to change without notice.
ENGLISH
10
Legal Regulations
Technical features
P = Power input
1
n = Spinning speed
0
= Displacement of the orbit
ø
= Sanding plate
= Mass
L = Acoustic power level
WA
L = Acoustic pressure level
pA
= Vibration
The values given are valid for nominal voltages [U] 230/240
V ~ 50/60 Hz - 110/120 V ~ 60Hz. For lower voltage and
models for specific countries, these values can vary.
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.

Declaration of Conformity

We declare under sole responsability that this product is in
coformity with the following standards or standardisation
documents: EN60745-1,
EN55014-2, EN61000-3-2, EN61000-3-3, according to the
provisions of the directives 2006/42/CE, 2014/30/EU.
10
EN60745-2-3, EN55014-1,
Ramiro de la Fuente
Director Manager
January 5, 2017