Peg-Perego VIAGGIO 2-3 FLEX Notice D'emploi page 24

push the side button and turn the
knob anti-clockwise.
6• The height of the backrest may
be adjusted: push the handle on
the rear of the backrest upwards
(1) and at the same time lift the
entire backrest (2) to the desired
position. To lower the backrest, pull
the handle (1) and at the same time
push the backrest downwards (2).
This operation is required as your
child grows.
7• Viaggio2-3 Flex is fitted with a
reclining system that guarantees
maximum comfort. To recline the seat,
pull the handle (fig_a) on the front
and simultaneously recline the product
(fig_b).
8• Viaggio2-3 Flex is fitted with two
lateral and removable cup holders.
How to attach the car seat
to the vehicle
if you own a car with
Isofix attachments
This type of attachment can be
used if your car is fitted with Isofix
hooks. Otherwise, go to the next
section. For further information on
the availability of these hooks and
their location, refer to the vehicle's
instruction manual.
Fastening the
guarantees greater stability and
safety in the vehicle, but cannot
replace the restraining function
of the vehicle's seat belts.
9• To bring out the attachments
located inside the Surefix Base, pull
the handle on the bottom front part
of the seat longitudinally towards
you (fig_a). The attachments will be
automatically ejected (fig_b). Repeat
to make sure the attachments
have
simultaneously.
10• Fix the attachments to the Isofix
hooks on the vehicle seat, ensuring
they "click" into place.
11• After fixing the attachments, pull
the front handle again (fig_a) and,
at the same time, push the car seat
towards the vehicle's seat (fig_b),
then release the handle.
12•
Isofix hooks and the car seat's Surefix
Base attachments are correct coupled
when a green signal appears above
the connectors (fig_a). A red signal
indicates that the attachments have
NOT been coupled correctly (fig_b).
13• To release Viaggio 2-3 Flex from
the vehicle seat, pull the handle (1)
until the Surefix Base attachments
are fully revealed. In so doing, the
yellow release buttons will be visible
on the sides of the base; pull the
two buttons (2) until you hear the
attachments click open. At this point
you can remove the car seat.
14• To reposition the attachments
inside the Surefix Base (when not
attachments
in use), pull the lever once more (1)
and simultaneously push one of the
two attachments in (2) until they
practically disappear
18
been ejected fully
IMPORTANT: The vehicle's
and