General Instructions; Transport And Handling - Certikin CTX QPA5S11001CT Notice D'installation, Mode D'emploi, Notice D'entretien

GENERAL INSTRUCTIONS

Transport and handling

Transport must be carried out respecting the orientation indicated on the package. Shipping by any means, even
if free of carriage of the purchaser or recipient, is carried out at the purchaser's risk. Claim for missing materials
must be made within 10 days of arrival of the goods. Whereas defective material within 30 days of receipt. If the
control unit is to be replaced, it must be agreed upon with authorised personnel or the authorised distributor.
Risks
After removing the packing, check the integrity of the control unit. If in doubt, do not use the device and contact a
qualified technician. The packing materials (such as plastic bags, polystyrene, etc.) must not be left within reach
of children since they are potentially dangerous.
Before connecting the control unit, make sure that the rating corresponds to those of the mains. The rating is
displayed on the adhesive label on the control unit itself.
Execution of the electrical system must comply with the standards that define professional workmanship in the
country where the system is made.
Use of any electrical device implies observance of some fundamental rules. In particular:
In case of failure and/or malfunctioning of the unit, switch it off and do not tamper with it. For any repairs, please
contact our service centres and request use of original spare parts. Failure to comply with the above can
jeopardise the safety of the device.
If you no longer decide to use an installed control unit, it is recommended to make it inoperable by unplugging it
from the mains.
In case of any leaks in the hydraulic system of the control unit (breakage of OR seal, valves, pipes), you must
stop operation by depressurising and disconnecting the supply pipes and then proceed with maintenance
operations using appropriate safety measures.
Assembly
All control units manufactured by us are usually supplied fully assembled. For more clarification regarding
exposure, please consult the attachment at the end of this manual where exploded drawings of the device and
all parts with relative nomenclature is reported in order to have a complete picture of the components. These
drawings are anyhow required to recognise the malfunctioning or defective parts. Other drawings regarding the
internal parts are reported for the same purposes, also in the attachment.
Disassembly
To disassemble the control unit or before carrying out any operations on it, you must:
Warranty
2 years (excluding parts subject to normal wear, namely: valves, fittings, pipe collars, tubes, seals and filter).
Improper use of the device will void this warranty. The warranty is understood as ex-works or authorised
distributors
do not touch the device with wet or damp hands or feet;
•
do not operate the device barefoot (e.g. pool systems);
•
do not leave the device exposed to atmospheric agents (rain, sun, etc.)
•
do not let children or an incapable person use the control unit unattended.
•
make sure it is switched off electrically (both polarities), disconnecting the conductors from
•
contact points of the mains by opening of the omnipolar switch with minimum 3 mm distance
between the contacts ();
disconnect any pumps and other devices connected to it;
•
close or disconnect the hydraulic supply circuit and discharge filters and probe holders.
•
ENGLISH 45