Limits Of Use; Electrical Safety; Protection Of The Electronic Section - Certikin CTX QPA5S11001CT Notice D'installation, Mode D'emploi, Notice D'entretien

use and maintenance of the device and its accessories must be carried out in accordance with the
•
instructions described in this manual;
this manual must be kept intact and legible in all its parts.
•

Limits of use

The device is only intended for the use for which it was expressly built. Any other use is considered
improper and therefore dangerous. The manufacturer declines all responsibility in the event of changes
and/or electrical and hydraulic connection errors caused by failure to comply with the instructions in the
installation, use and maintenance manual. Failure to comply with these instructions will immediately
render the warranty null and void.
Any operations and/or repairs inside the device must be carried out by qualified and authorised
personnel. We assume no liability due to failure to comply with this rule.

Electrical safety

In order to ensure maximum operator safety and correct operation of the device, you must operate within the
limits allowed and take all the precautions listed below:
Before use, make sure that all safety requirements are met. The appliance must not be
•
supplied or connected to other devices until the safety conditions are met.
Power the device exclusively with mains voltage according to specifications (230Vac 50/60
•
Hz)
Immediately replace damaged parts. Cables, connectors, accessories or other parts of the
•
device that are damaged or not operating properly must be replaced immediately. If so, contact
your nearest authorised technical assistance service.
Only use the accessories and peripherals specified by CERTIKIN. To ensure all safety
•
requirements, you must only use the accessories specified in this manual or in those of individual
devices assembled on the station, which have been tested with each other. Use of accessories
and consumables from other manufacturers, or not specifically indicated by CERTIKIN, does not
guarantee safety and correct operation of the device. Only use peripheral devices that meet the
standards of its category.
Safety of operating environment
The CONTROL PANEL PH-RX is protected against liquids seeping in. Do not subject the device to the risk of
dripping and splashing, and do not use the device in rooms where there are such risks. If liquids accidentally spill
into the devices, they must be immediately switched off, cleaned and checked by authorised personnel.
On completion of installation and calibration, it is recommended to reposition the protection control panel of
CONTROL PANEL PH-RX.

Protection of the electronic section

Protection of the pump , IP65
•
EMI/RFI
•
Use the device within the environmental limits of temperature, humidity and pressure specified. The tool
is designed to work in the following environmental conditions:
Working ambient temperature
•
storage and transport temperature
•
relative humidity
•
IEC EN 61326 IEC EN 61010-1
0°C ÷ +50°C
-25°C ÷ +65°C
10% ÷ 95%RH - Non-Condensing
ENGLISH 43