Information On Recycling And Reuse Of Materials; Focus On Critical Components - Certikin CTX QPA5S11001CT Notice D'installation, Mode D'emploi, Notice D'entretien

The device must be perfectly installed in the system, which must be in accordance with the safety rules in force
in the country of installation. The system must be maintained in full compliance with the safety rules provided for.
The parameters set on the control unit of the analyser must comply with the statutory and regulatory
requirements. Reports of failure of the control unit must be placed in a room that is constantly controlled by
operating personnel or assistance of the system.
Failure to comply with even one of these conditions can cause the "logic" of the control unit to operate
in a potentially dangerous way for users of the service.
Therefore service personnel and/or maintenance technicians are recommended to operate with the utmost
diligence, immediately reporting any deviation of the safety parameters so as to avoid potentially dangerous
conditions.
Since the above considerations do not fall under the possibility of control by the product in question, the
manufacturer is not responsible in any way for any damages that such malfunctions can cause to people or
property.

Information on recycling and reuse of materials

In accordance with specific EU directives, CERTIKIN focuses on continuous improvement of the design and
production process of its devices in order to minimise the negative impact on the environment with regard to
management of component parts, supplies, packaging and the device at the end of its lifespan.
The packages are designed and produced in order to permit their reuse or recovery, including recycling of most
materials, and to minimise the amount of waste or residues to be disposed of. To ensure proper environmental
impact, this device was designed with maximum circuit miniaturisation, with the least possible differentiation of
materials and components, with a selection of substances that guarantee maximum recyclability and maximum
reuse of the parts and disposal without any ecological impacts.
The device is manufactured in such a way as to ensure easy separation or removal of materials containing
pollutants compared to others, especially during maintenance and replacement of parts.
Disposal/recycling of packaging, supplies and the device itself at the end of its lifespan must be made in
accordance with the regulations and standards currently in force in the country where the device is
used.

Focus on critical components

An LCD (Liquid Crystal Display) is assembled inside the tool pumps and contains small amounts of toxic
materials.
ENGLISH
44