Important - Waring Commercial WSB40 Manuel D'utilisation

To wash and sanitize the Waring
1. Rinse the exterior and interior stainless steel portion of the
Waring Quik Stik Plus
®
Scrub and flush the exterior and under the blade guard/blade to
dislodge and remove as much food residue as possible.
2. Wipe down the exterior of the plastic housing and the stainless steel
portion of the Waring
cloth or sponge dampened with the washing solution.
3. Immerse approximately ¾ of the length of the stainless steel portion
in a container of the washing solution and run for two (2) minutes on
the Hi speed setting.
4. Repeat steps two (2) and three (3) using clean rinse water in place of the
washing solution.
IN ORDER TO MINIMIZE THE POSSIBILITY OF SCALDING,
TEMPERATURE OF THE WASHING SOLUTION AND RINSE
WATER MUST NOT EXCEED 115°F (46°C).
5. Wipe down the exterior of the plastic housing and the stainless steel
portion of the Waring
cloth or sponge dampened with the washing solution.
6. Immerse approximately ¾ of the length of the stainless steel shaft
in a container of sanitizing solution and run for two (2) minutes on
the Hi speed setting.
6. DO NOT RINSE AFTER SANITIZING IS COMPLETE.
Allow to air-dry before use.
DO NOT IMMERSE PLASTIC MOTOR HOUSING IN WASHING
SOLUTION, RINSE WATER, OR SANITIZING SOLUTION.
PREVENT LIQUID FROM RUNNING INTO PLASTIC HOUSING
BY WRINGING ALL EXCESS MOISTURE FROM CLOTHS OR
SPONGES BEFORE USING THEM.
6
Quik Stik Plus
®
Immersion Blender under running water.
®
Quik Stik Plus
®

IMPORTANT

Quik Stik Plus
®
NOTE
Immersion Blender:
®
Immersion Blender with a soft
®
Immersion Blender with a soft
®