Recirculation Mode - AEG DK 9160 Notice D'utilisation Et D'installation

equal to the outlet hole.
• Should there already be a pipe of diameter
125 or 120 mm that ducts to the outside
through the walls, it is possible to use the
150/125-120 mm reduction flange
provided. In this case the hood will be
slightly noisier.
• For DK 9060-9090 only: The valve located
inside the discharge hole of the range
hood A allows, anyhow, a minimum air
exhaustion even when the electric valve
switch is in OFF ( O ) position. This is a
useful function, since it grants a
continuous air exchange inside the
kitchen.
It is possible to use this function adjusting
the valve opening properly.
For this purpose it is necessary to change
the position of the screws which lock the
adjustable closings positioned on the valve
surface. Fig 1a.

Recirculation mode

• The air is filtered through a charcoal filter and returned to the
kitchen.
• You will need an original charcoal filter for the recirculation mode.
(See Special Accessories).
• Fix the deflector using 2 screws Ø 2,9x13 mm. Fig. 2.
• Optionally, the position of the chimney elements can be changed.
When using the hood in the recirculation mode the chimney must be
fixed at the top, with the air outlet grill at the side.
70
Fig. 2
Fig. 1a