Description Of The Appliance; Extraction Mode - AEG DK 9160 Notice D'utilisation Et D'installation

• When the hood is used in its extraction mode, the following rules
must be followed to obtain optimal operation:
- short and straight outlet hose
- keep bends in outlet hose to a minimum
- never install the hoses with an acute angle, they must always
follow a gentle curve.
- keep the hose as large as possible (preferably the same diameter
as the outlet hole).
- the length should be no more than:
3 metres with one 90° bend
2 metres with two 90° bends
Bends of more than 90° will reduce the efficiency of the hood and
reduce the airflow.
• Failure to observe these basic instructions will drastically reduce the
performance and increase the noise levels of the extractor hood.

Description of the Appliance

• The cooker hood is designed to extract unpleasant odours
from the kitchen, it will not extract steam.
• The hood is supplied as an extractor unit and can also be used with
a recirculation mode by fitting a charcoal filter.
• In some models the charcoal filter is supplied. The hood, therefore,
can be used immediately in the recirculation mode. We advise
removing the charcoal filter to use the hood in the extraction mode.
• Only for HC 5690: The cooker hood is supplied ready for use as a
recirculation hood and may be used for extraction by removing the
charcoal filter which has been fitted inside the cooker hood.
• For DK 9060-9090 only: The hood is supplied as an extractor unit.
Please disconsider the instructions related to the
recycling version, to the installation, use and
maintenance of the charcoal filter and of the
deflector.
The hood is not supplied with an
internal motor and must be connected
with an exetrnal aspirating motor unit.

Extraction mode

• In this mode fumes are extracted to
the outside via a hose connected to
the coupling ring A. Fig. 1.
• In order to obtain the best performan-
ce the hose should have a diameter
Fig. 1
69