Yamaha ATS-1050 Mode D'emploi page 20

The power of the The power of the TV was on when
you performed the learning
sound bar and of
operation.
the TV switch in
the opposite
direction. (For
example, the TV
is turned off if
the sound bar is
turned on.)
(when TV's
remote control
learning function
is used)
Problem Cause
Cannot make the is not selected as the
sound bar pair input source.
with the
The device does not support
Bluetooth
A2DP.
device.
A
want to pair with the sound bar
has a password other than
"0000."
The sound bar and device are too
far apart.
There is a device (microwave
oven, wireless LAN, etc.) that
outputs signals in the 2.4 GHz
frequency band nearby.
Another
connected.
18
Press the power key on the TV and
(power) on the rear panel of the sound
bar to turn them on and then press the
power key on the TV's remote control
to turn them off.
Remedy
Select as the input source.
Perform pairing operations with a
device which supports A2DP.
adaptor, etc., that you Use a adaptor, etc., whose
password is "0000."
Move the device closer to the sound
bar.
Move the sound bar away from the
device that is emitting radio frequency
signals.
If the device is equipped
with the wireless LAN function, turn off
the wireless LAN function, and turn on
the function only.
device is Terminate current
connection, and perform pairing with
the new device.
Cannot make a Another device is
Bluetooth
connected.
connection.
More than nine devices are paired
and the oldest pairing information
is deleted.
Cannot make a There is a problem within the
Bluetooth
sound bar.
connection (the
BLUETOOTH
indicator
continues to
flash rapidly).
No sound is The connection of the
sound bar with the device is
produced or the
disconnected.
sound is
interrupted
is not selected as the
during playback.
input source.
The sound bar and device are too
far apart.
There is a device (microwave
oven, wireless LAN, etc.) that
outputs signals in the 2.4 GHz
frequency band nearby.
The device is not set to send
audio signals to the
sound bar.
Playback on the device has not
been performed.
The device's volume is set to
minimum.
The sound bar cannot make multiple
connections. Terminate
current connection, and
make connection for the desired
device.
Perform pairing again. The sound bar
can retain pairing information for up to
eight devices. When pairing a ninth
device, pairing data for the device with
the oldest connection date will be
deleted.
Unplug the power cable from the AC
wall outlet and contact the nearest
authorized Yamaha dealer or service
center.
Perform connection
operations again (p.10).
Select as the input source.
Move the device closer to the sound
bar.
Move the sound bar away from the
device that is emitting radio frequency
signals.
If the device is equipped
with the wireless LAN function, turn off
the wireless LAN function, and turn on
the function only.
Change the audio output setting and
connection setting on the device.
Perform playback on the device.
Turn up the device's volume level.