Starting The Pressure Washer - Simpson 30A Manuel D'utilisation Et D'entretien

The high pressures created by a pressure washer can cause fluid injection injuries,
severe lacerations, amputations, and / or death. To avoid these hazards, always aim
the spray gun and lance in a safe direction when using the pressure washer and never
attempt to touch a leak in a high-pressure hose or fitting.

STARTING THE PRESSURE WASHER

1. Connect the hoses as instructed on Page 11.
2. Turn on the water and purge the system of air as instructed on Page 12.
3. Insert the desired nozzle as instructed on Page 13.
4. Make sure the master ON/OFF switch is in the OFF (0) position.
5. Plug the electrical power cord into a grounded receptacle, rated for voltage and
current requirements of the pressure washer, that was properly installed in
accordance with all local codes and ordinances.
Page 15
WARNING: WARNING:
30 ampere style
250v 30A 6-30R
INJECTION INJURY
250v 50A 6-50R