Husqvarna 530iP4 Manuel D'utilisation page 14

Note: Refer to the battery and battery charger manuals
for more information.
To check before starting
1. Inspect the working area. Remove any objects that
could be thrown out.
2. Check the saw chain. Never use blunt, cracked or
damaged equipment.
3. Check that the product is in perfect working order.
4. Check that all nuts and screws are tight.
5. Make sure the chain is adequately lubricated, refer
To lubricate cutting equipment on page 21 .
to
6. Check that the saw chain always stops when the
engine is idling.
7. Only use the product for the purpose it was intended
for.
8. Make sure the handle and safety features are in
order. Never use a machine that has any parts
missing or has been modified in relation to the
specification.
To start the product
1. Push and hold the start/stop button until the green
LED is on.
2. Use the power trigger to control the speed.
To use the SavE function
This product has a power saving function, SavE. The
SavE function decreases the chain speed and gives the
longest operation time from the battery.
Note: The SavE function does not decrease the cutting
power of the product.
1. Push the SavE button on the keypad.
2. Make sure that the green LED comes on.
14
3. Push the SavE button again to disconnect the
function. The green LED goes out.
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Push the start/stop button until the green LED is off.
3. Push the release buttons on the battery and pull the
battery out.
To use the product
WARNING: Do not stay directly below a
branch that is being cut. This can result in
death or injury.
• Be careful when you operate near overhead power
lines. Falling branches can result in short-circuiting.
• If possible, position yourself so that you can make
the cut at right angles to the branch.
90°
783 - 003 - 28.05.2019