DeWalt DXAEC210 Guide D'utilisation page 7

Base Stand and Wheel Set Installation
PARTS:
A
E
B D F
C
A. Base Stand D. Ø4mm Spring Washer
B. Ø4mm Plain Washer (7 in total: 4 for Base Stand,
3 for Wheel Set Lock)
(4 in total)
E. Wheel Set Lock
C. Base Stand Screw
(4x22mm) (4 in total) F. Wheel Set Lock Screw
(4x8mm) (3 in total)
DXAEC210_ManualENFRSP_062117.indd 12-13
ASSEMBLY:
1. Turn the unit upside down with the unit base at top as shown.
2. Position the Base Stand as shown in the illustration on the following
page, aligning the four Base Stand Screws, Ø4mm Spring Washers
and Ø4mm Plain Washers with the Base Stand Screw Holes
through the apertures on the Base Stand in the sequence shown
in the illustration.
3. Screw the four Base Stand Screws into the Base Stand Screw
Holes. Do not over-tighten.
4. Position the Wheel Set Assembly as shown in the illustration.
5. Align the Wheel Set Lock with the three Wheel Set Screw Holes. It
should be centered over the Wheel Shaft Slots.
6. Screw the three Wheel Set Lock Screws with the three Ø4mm
Spring Washers in the sequence shown in the illustration into the
Wheel Lock Screw Holes through the Wheel Set Lock. Do not
over-tighten.
12
4mm
Spring
Washers
Wheel Set Lock
Screw Holes
Base Stand
Screws
Base Stand Ø4mm Plain
Washers
Ø4mm Spring
Washers
Base Stand
Screw Holes
13
Wheel Set Lock
Wheel
Wheel Set
Shaft Slot
Lock Screws
6/21/2017 10:11:38 AM