Abus FUMO50010 Instructions D'installation Et D'utilisation page 29

Step 7: Assigning components
 Select:
Installer mode -> Components -> RF repeater > Edit > RF repeater X
 Select the desired repeater from the list of paired repeaters. Here you can select or deselect
the detectors to be repeated in the corresponding detector groups. For further details,
please refer to the instructions of the alarm panel or wireless extension. You can also
change the name of the repeater after selecting the corresponding submenu.
If a component is deleted from the alarm panel, it is automatically deleted from the
repeater.
Note
Step 8: Test the system
 Test the system fully.
Signal strength
 Signal strength of the repeater on the alarm panel
Installer mode > Test > Signal strengths > RF repeater
 Signal strength of the alarm panel and components on the repeater
Installer mode > Test > Signal strengths > RF repeater components
 Select the corresponding repeater. A list of all possible components will appear. After select-
ing a component, you will see its signal strength on the repeater.
 For more details, please refer to the corresponding instructions of the alarm panel or wire-
less extension.
 Signal strength of the components on the alarm panel
Installer mode > Test > Signal strengths
 Select the desired component. You will see two columns for the components which are be-
ing repeated.
The right column shows the original signal from the component to the alarm panel.
The left column shows the repeated signal strength from the repeater to the alarm panel.
For more details, please refer to the corresponding instructions of the alarm panel or wireless
extension.
 Exit installer mode on the alarm panel. The system is now ready.
Repeat alarm panel
Repeat detectors
Repeat wireless control panel
Repeat outdoor sirens
Repeat indoor sirens
Repeat door locks
Installation
29 | EN