Abus FUMO50010 Instructions D'installation Et D'utilisation page 28

Installation
 The repeater will then send a pairing signal to the alarm panel. The alarm panel will rec-
ognise the repeater. Once the pairing signal has been received by the wireless alarm
system, it will emit two beeps. The message "RF repeater added" and the incoming sig-
nal strength will be displayed.
 Confirm the successfully completed teach-in on the control panel.
Step 6: Switch on the repeater
 Connect the batteries.
 Insert the power supply unit into the socket
The batteries and power supply unit must be connected to switch on and operate
the repeater.
Note
Insert the cables into the guides provided. Otherwise, the cables may be crushed.
Important
 Close the cover, tighten the cover fixing screws and close the covers of the screws.
28 | EN
Figure 4
Figure 5