Special Functions; Volume Punch-Through - Hama 00221057 Instructions De Fonctionnement

5.4 Mode Function - 2 device levels
With this remote control, the control of the various devices is
divided into 2 levels.
Level 1
Direct selection via the respective
device button
TV
STB
SOUND
DISC
• To control second-level devices, proceed as follows:
• Press the "Mode (18)" button until the LED (20) lights up.
• Press the corresponding device button.
5.5 Code recognition
Code recognition offers you the ability to determine a code you
have already saved.
5.5.1 Press the "Setup (11) " button until the LED lights up
permanently.
5.5.2 Use the device button to select the device to be operated
(e.g. TV). If the selection is successful, the LED flashes
once and then lights up permanently.
5.5.3 Press the "Setup (11) " button. The LED flashes once
and then lights up permanently.
5.5.4 Press one of the number buttons from 0 to 9 to search for
the first digit. The LED flashes once for the first digit of
the five-digit code number.
5.5.5 Repeat step 5.4.4 for the second, third, fourth and fifth
digits respectively.
5.5.6 You can then enter the determined code in the table
below if you need it again at a later time (e.g. after
accidentally deleting the remote control settings).
TV STB
AMP AUX
Level 2
"Mode" button + corresponding
device button
AMP
AUX
DEVICE 7
DEVICE 8
CODES
SOUND DISC
DEVICE 7 DEVICE 8

6. Special functions

6.1 Channel punch-through
With the channel punch-through function, the Ch+ or Ch-
commands can bypass the currently controlled device and
change the channels of a second device. All other commands
are unaffected.
To activate the channel punch-through function:
• Press the desired device button (e.g. TV).
• Press and hold the "P+" button.
• Press the desired device button (e.g. STB).
• Release the "P+" button again (the LED flashes once when
the setting is activated).
To deactivate the channel punch-through function:
• Press the desired device button (e.g. TV).
• Press and hold the "P-" button.
• Press the desired device button (e.g. STB).
• Release the "P-" button again (the LED flashes twice when
the setting is deactivated).

6.2 Volume punch-through

With the volume punch-through function, the V+ or V-
commands can bypass the device currently being controlled
and adjust the volume of a second device. All other
commands are unaffected.
To activate the volume punch-through function:
• Press the desired device button (e.g. TV).
• Press and hold the "V+" button.
• Press the desired device button (e.g. STB).
• Release the "V+" button again (the LED flashes once when
the setting is activated).
To deactivate the channel punch-through function:
• Press the desired device button (e.g. TV).
• Press and hold the "V-" button.
• Press the desired device button (e.g. STB).
• Release the "V-" button again (the LED flashes twice when
the setting is deactivated).
6.3 Macro Power
Macro Power allows you to switch two AV devices on/off
simultaneously.
To activate the Macro Power function:
• Press the desired device button (e.g. TV).
• Press and hold the "Power (19) " button.
• Press the desired device button (e.g. STB).
• Release the "Power (19) " button again (the LED flashes
once when the setting is activated).
7