Installation Instructions; Pre-Installation Instructions - Ge Nccc24Bt4 Manuel Du Propriétaire Et Instructions D’installation

Installation Instructions

Pre-Installation Instructions

1. Checking Product Received
After receiving the product, please check if there is any damage caused by transportation. Shipping damage
is the responsibility of the carrier. Verify the model number, specifications and accessories are correct prior to
installation. The distributor or manufacturer will not accept claims from dealers for transportation damage or
installation of incorrectly shipped units.
2. Before Installation
Carefully read all instructions for the installation prior to installing product. Make sure each step or procedure is
understood and any special considerations are taken into account before starting installation. Assemble all tools,
hardware and supplies needed to complete the installation. Some items may need to be purchased locally. Make
sure everything needed to install the product is on hand before starting.
3. Codes & Regulations
This product is designed and manufactured to comply with national codes. It is installer's responsibilities to install
the product in accordance with such codes and/or any prevailing local codes/regulations. The manufacturer
assumes no responsibilities for equipment installed in violation of any codes or regulations.
These instructions are intended as a general guide and do not supersede local or national codes in any way.
Authorities who have jurisdiction should be consulted before installation.
4. Replacement Parts
When reporting shortages or damages, or ordering repair parts, give the complete product model and serial
numbers as stamped on the product. Replacement parts for this product are available through your contractor or
local distributor.
Location
WARNING
This coil is designed for indoor installation
only. Do not install it outdoors.
• When installing the coil, take consideration to minimize the length of refrigerant tubing as much as possible.
• Do not install the air handler in a location either above or below the condenser that violates the instructions
provided with the condenser.
• Service clearance is to take precedence. Allow a minimum of 25" in front of the unit for service clearance, as shown
below.
6
Not suitable for use with ammonia.
49-5000775 Rev. 0