Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DYNAMIC
EN
CONDENSER ASSEMBLY:
!
IMPORTANT: Depending on the vehicle, we
can position the pipe outputs on the right or
left side.
1
Note: When the installation is carried out
by just one person, mark the bores with the
indicated measurements, taking into account
the pipe length (from the evaporator to the
condenser).
2
Remove the cover and release the condenser
fan cable.
3
If this is carried out by 2 people, introduce
the capacitor base, placing it at the most
appropriate part of the rear of the cabin,
taking into account the pipe length from
the evaporator to the condenser, and
secure with at least 6 bores.
4
First make the (2) upper bores (X) at Ø 9,
position M6 rivet nuts and position the base
with screws 6/100x30, mark and make the
rest of the bores (Y), position the nuts.
4
X
Y
ALWAYS
Left pipe output
Right pipe output
491
®
3
Publicité
Table des Matières
