Siemens EQ.500 classic Notice D'utilisation page 66

en Cleaning and servicing
the calc'nClean programme when
your appliance prompts you. The pro-
cess takes approx. 43 minutes.
Requirement: The brewing unit is
cleaned.
→ "Cleaning brewing unit", Page 63
Press
1.
Use and
2.
ing and care" and press
Use and
3.
"calc'nClean" and press
To start the programme, press
4.
a The display will guide you through
the programme.
Empty and insert the drip tray.
5.
If there is a water filter, remove it.
6.
Press ⁠ .
7.
Empty the water tank.
8.
Fill a container with 0.5 l lukewarm
9.
water.
Add a Siemens descaling tablet to
10.
the water and stir until the tablet is
fully dissolved.
Pour the descaling solution into
11.
the water tank up to the calc mark
and press
Place a container with a capacity
12.
of min. 0.5 l under the outlet sys-
tem.
Place the end of the suction pipe
13.
in the container and press
a The descaling programme will run
for approx. 20 minutes.
Rinse the water tank.
14.
Press ⁠ .
15.
If there is a water filter, insert the
16.
water filter.
→ "Inserting and activating the wa-
ter filter", Page 57
Press ⁠ .
17.
Fill the tank with fresh water up to
18.
the "max" mark.
66
⁠ .
to select "Clean-
⁠ .
to select
⁠ .
⁠ .
Press
19.
a The programme takes ap-
prox. 1 minute and rinses the ap-
pliance.
Empty and insert the drip tray.
20.
Open the ground coffee compart-
21.
ment.
Place one Siemens cleaning tablet
22.
into the ground coffee compart-
ment.
Close the ground coffee compart-
23.
ment and press
⁠ .
Place a container with a capacity
24.
of min. 0.5 l under the outlet sys-
tem and press
a The cleaning programme takes ap-
prox. 7 minutes.
Empty and insert the drip tray.
25.
Thoroughly clean the suction pipe
26.
of the milk system.
a The program has ended and the
appliance is ready for operation.
⁠ .
⁠ .
⁠ .
⁠ .