Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
> > Instruction for use
•
Connect the electric plug to the current outlet; the appliance goes into standby
mode.
Make sure that the supply voltage corresponds with the data
indicated on the appliance nameplate.
"ON/OFF" button
NTC
The appliance does not operate in standby mode.
-
Press the "ON/OFF" button to start the appliance; the respective LED switches
on.
-
To switch the appliance off, press the "ON/OFF" button again.
"SPEED" button
NTC
Press the "SPEED" button to adjust the ventilation speed from LOW > MID >
-
HIGH > MAXIMUM; the respective LEDs switch on.
"TEMPERATURE" button
NTC
Press the "TEMPERATURE" button to adjust the temperature between 25°C
-
and 35°C; the respective LEDs switch on.
When the room temperature reaches the 25°C/35°C set, the appliance
interrupts operation; the respective LEDs switch off.
Instead, when the room temperature drops below 23°C/33°C, the
appliance resumes operation with the previously-set values; the respective
LEDs switch on.
"TIMER" button
-
Press the "TIMER" button to activate or deactivate the timer.
"SWING" button
-
Press the "SWING" button to activate or deactivate the swing.
"POWER" button
-
Press the "POWER" button to activate the heat function and adjust power be-
tween 900W (hot air) and 1500W (hotter air); the respective LEDs switch on.
-
Press the button a third time to deactivate the heat function.
48
USE
HET 1031 FAN
Publicité
Table des Matières
