ohmex HET 1031 FAN Manuel D'utilisation page 48

EN
• Do not obstruct the openings and slots for ventilation and heat discharge
• Do not place the fan above or near another heat source. WARNING: AVOID COVERING
THE FAN TO PREVENT IT FROM OVERHEATING.
• The fan may cause the risk of fire if, while in operation, is covered by or comes into
contact with inflammable material including curtains, drapery, blankets, etc. KEEP THE
FAN AWAY FROM THESE MATERIALS.
☞
• Do not place the fan on soft surfaces, like a bed, where openings may
become blocked. Always place the fan on a stable, flat, level surface when
operating, to avoid the chance of the fan overturning. Locate the power
cord so the fan or other objects are not resting on it.
• Make sure that the power cord is not in the way when moving around the
appliance in order to prevent that someone could, even inadvertently,
pull it toppling the appliance.
• Protect the appliance and the remote control from impacts.
• Do not wrap the power cord around the appliance immediately after
having disconnected the plug from the power outlet.
• During functioning, the power outlet must be easily accessible if its
necessary to disconnect the appliance.
Place the appliance far from sinks and taps.
• In case of deterioration, the power cord must be replaced by the manufacturer, by the
assistance service or by a qualified person.
• Avoid using the appliance beyond the intended uses.
• Avoid disconnecting the appliance by pulling the power cord.
• Do not move the appliance while it's working.
• Wait for the appliance to be completely cooled before storing it.
• The appliance has not been intended to be used under rain and must not be deposited
outside or in damp environments.
☞
Do not use the appliance in environments with explosives, combustible
gasses or inflammable liquids (varnishes, glues, spray cans, etc.). EXPLOSION
AND FIRE DANGER.
44
GENERAL WARNINGS
Burns danger!
HET 1031 FAN