Din Front/Rear-Mount - Pioneer SDV-P7 Manuel D'installation

Installation
Note:
• Before finally installing the unit, connect the • When mounting this unit, make sure none of the
wiring temporarily, making sure it is all connected leads are trapped between this unit and the sur-
up properly, and the unit and the system work rounding metalwork or fittings.
properly. • Do not mount this unit near the heater outlet,
• Use only the parts included with the unit to ensure where it would be affected by heat, or near the
proper installation. The use of unauthorized parts doors, where rainwater might splash onto it.
can cause malfunctions. • Before drilling any mounting holes always check
• Consult with your nearest dealer if installation behind where you want to drill the holes. Do not
requires the drilling of holes or other modifications drill into the gas line, brake line, electrical wiring
of the vehicle. or other important parts.
• Install the unit where it does not get in the driver's • If this unit is installed in the passenger compart-
way and cannot injure the passenger if there is a ment, anchor it securely so it does not break free
sudden stop, like an emergency stop. while the car is moving, and cause injury or an
• The semiconductor laser will be damaged if it accident.
overheats, so don't install the unit anywhere hot • If this unit is installed under a front seat, make sure
— for instance, near a heater outlet. it does not obstruct seat movement. Route all leads
• If installation angle exceeds 30° from horizontal, and cords carefully around the sliding mechanism
the unit might not give its optimum performance. so they do not get caught or pinched in the mecha-
(Fig. 7) nism and cause a short circuit.
• Do not mount this unit on the spare tire board or
any other unstable place.
• Do not mount this unit anywhere that gets the sun
and so becomes hot, like on the dashboard or the
rear shelf.
• Mount this unit on a flat surface.
MODE Switch Setting
Before installing, use a pen tip or other thin,
Fig. 7 pointed instrument to set the MODE Switch to
the appropriate position for the component you
are using it with.
STAND ALONE
IP-BUS

DIN Front/Rear-mount

This unit can be properly installed either from "Front" (conventional DIN Front-mount) or
"Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit
chassis). For details, refer to the following illustrated installation methods.
DIN Front-mount
Installation with the rubber bush (Fig. 8)
Holder
After inserting the holder into the
dashboard, then select the appropriate
tabs according to the thickness of the
Dashboard dashboard material and bend them.
(Install as firmly as possible using the
182
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
53
Rubber bush
Screw
Removing the Unit (Fig. 9) (Fig. 10)
5
Frame
Insert the release pin into the hole in 6
the bottom of the frame and pull out
to remove the frame.
(When reattaching the frame, point
the side with a groove downwards
and attach it.)
Insert the supplied extraction keys
into the unit, as shown in the figure,
until they click into place. Keeping
the keys pressed against the sides of
the unit, pull the unit out.
Fig. 8
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 11)
Frame
Insert the release pin into the hole in
the bottom of the frame and pull out
to remove the frame.
Fig. 9
(When reattaching the frame, point
the side with a groove downwards
and attach it.)
Fig. 10
<ENGLISH>
Fig. 11