Connecting The Units - Pioneer SDV-P7 Manuel D'installation

Connecting the Units

When Connecting the Head Unit
IP-BUS STAND ALONE
This product
Head Unit
(sold separately)
Not used.
Blue
15 cm
Blue
Blue
40 cm
IP-BUS cable
(sold separately)
AV-BUS cable
(sold separately)
Red
IP-BUS cable
(supplied with the TV tuner)
AV system display
(e.g. AVX-7300)
(sold separately)
Black
FM MODULATOR
IP-BUS MAIN UNIT
Hide-away TV Tuner
(e.g. GEX-P7000TV)
IP-BUS AV MASTER
(sold separately)
Green
Red
20 pin cable
(supplied with the display)
When Connecting the Display with RCA Input Jacks
White (audio output (Left))
IP-BUS STAND ALONE
Red (audio output (Right))
Yellow (front
video output)
RCA cable (supplied)
RCA cable (sold separately)
To video input
To audio inputs
This product features a built-in
remote sensor. If it is installed in a
location where reception of the
remote control signal is not
possible, use a separately sold
Display with RCA
remote sensor.
input jacks
Connecting a rear display
Instead of video output for viewing on a front display, you can connect for video output
enabling viewing on a rear display (for passengers in the rear of the car). If you decide to
use a rear display, be sure to follow the warnings on the next page.
Fig. 3
When Using a Display Connected Rear Video Output
This product's rear video output is for connection of a display to enable passengers in the
rear seats to watch the DVD or Video CD.
WARNING
• NEVER install the display in a location that enables the Driver to watch the DVD or
Video CD while Driving.
This product
IP-BUS STAND ALONE
Remote sensor
(sold separately)
Yellow (rear
video output)
RCA cable (supplied)
RCA cable (sold separately)
To video input
To audio inputs
Display with RCA
input jacks
Fig. 4
Connecting the Power Cord
This product comes with two kinds of power cord. Use the short cord when installing this
product in the dashboard, and the long cord when installing it on the floor.
Note:
• Use commercially available installation parts to install this product on the floor.
White (audio output (Left))
This Product
Red (audio output (Right))
This product
Light green
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side
of the parking brake switch.
Fig. 5
<ENGLISH>
Connection method
1. Clamp the parking brake
switch power supply side
lead.
2. Clamp firmly with
needle-nosed pliers.
Note:
• The position of the parking brake switch depends
on the vehicle model. For details, consult the
vehicle Owner's Manual or dealer.
Power supply side Parking brake switch
Ground side
Red
Fuse resistor To electric terminal controlled by ignition
switch (12 V DC) ON/OFF.
Yellow
To terminal always supplied with power
Fuse holder
regardless of ignition switch position.
Black (ground)
To vehicle (metal) body.
Fig. 6