Setup; Step 1: Connect Your Monitor To Your Computer; Step 2: Connect The Power Cord - Sony Trinitron CPD-G200 Mode D'emploi

Setup

Before using your monitor, check that the following accessories
are included in your carton:
• Power cord (1)
• Macintosh adapter (1)
• Windows Monitor Information Disk (1)
• Warranty card (1)
• Notes on cleaning the screen's surface (1)
• This instruction manual (1)
Step 1: Connect your monitor to
your computer
Turn off the monitor and computer before connecting.
Note
• Do not touch the pins of the video cable connector as this might bend
the pins.
x Connecting to an IBM PC/AT or compatible
computer
AC IN
to video output
IBM PC/AT or
compatible computer
6
x x x x Connecting to a Macintosh or compatible
computer
Use the supplied Macintosh adapter.
AC IN
Macintosh adapter (supplied)*
Macintosh or to video
compatible computer output
* Connect the supplied Macintosh adapter to the computer before
connecting the cable. This adapter is compatible with Macintosh LC,
Performa, Quadra, Power Macintosh and Power Macintosh G3 series
computers (sold before January, 1999). If you are connecting to a
Power Macintosh G3 series that sold after January 1999, you will need
a different adapter (not supplied). Macintosh II series and some older
versions of PowerBook models may need an adapter with micro
switches (not supplied).

Step 2: Connect the power cord

With the monitor and computer switched off, first connect the
power cord to the monitor, then connect it to a power outlet.
AC IN
to AC IN
to a power outlet
power cord (supplied)