To Replace Filter; Filter Change Confirmation - Bosch CS LD 1.0 Guide D'utilisation

en | 42 | CS LD 1.0 | Maintenance
When this screen appears, the only
control that will function (and the
only operation that is possible) is
the power button.
7.1.2

To Replace Filter

Unscrew filter tip as shown in Fig
13 to access the filter. The filter
is located in the threaded base of
the tip. It may be necessary to use
a pointed object like a paper clip
to remove the filter.
1
Fig. 12: Sensor components
1 Filter tip
2 Sensor filter
7.1.3 Filter Change
Confirmation
When Check Sensor Filter mes-
sage screen appears, pressing the
power button leads
to the screen shown in Fig. 14,

"Filter Change Confirmation".

|
F 002 DG9 H12 2021-04-08
2
Bosch Automotive Service Solutions GmbH
Fig. 13: Filter change confirmation
display
Two options are now possible:
•
If the filter was checked, and
replaced if necessary, press
the button beneath the
The unit will begin the warm-up
operation, the internal timer is
reset, and normal operation may
resume.
•
If the decision to postpone che-
cking the filter is made, press
the button beneath the icon.
The unit will begin the warm-up
operation and normal operati-
on may resume; HOWEVER the
internal timer is not reset and
when the CS LD 1.0 is powered
ON subsequently, the "Check
Sensor Filter" screen will reap-
pear and the decision tree must
be repeated.
icon.