Commissioning; Operating Instructions; Understanding Sensitivity Levels And Modes; Adjusting Sensitivity Levels - Bosch CS LD 1.0 Guide D'utilisation

Fig 1.1: HMI View of CS LD 1.0
1. Battery status indicator
2. Status /Leak size indicator
3. Audio status indicator
4. Audio ON/OFF button
5. Power button
6. Sensitivity / Mode selection button
7. Leak tracing mode (Graph) button
8. Sensitivity level / mode indicator
9. LCD
10. Alarm Indication (Audio off only)
5.

Commissioning

1. Remove the transport pa-
ckaging.
2. Check if all items have been
delivered as per section 4.2.
3. Check the CS LD 1.0 for dama-
ges. If there are damages, con-
tact Bosch customer service.
4. Read this operators manual.
5. Charge the CS LD 1.0 (refer
to Sec. 7.4.2) using the provi-
ded charging block and cable.
An alternate charger certified
according to local guidelines
Bosch Automotive Service Solutions GmbH
Commissioning | CS LD 1.0 | 35 | en
with output rating of 5V DC
1A minimum may be used,
however charging time may be
increased.
6. Once connected to the charger,
the CS LD 1.0 LCD will illumi-
nate to indicate that the battery
is charging and shows % charge
status. If the display does not
illuminate, check the power
source or verify the charger
compatibility and/or connec-
tion.
i i
Avoid discharging the battery
completely. Recharging a par-
tially discharged battery more
frequently is better for the life
of a lithium-ion battery.
i i
Once fully charged, as in-
dicated on the display, the
CS LD 1.0 is ready for use.
6. Operating
Instructions
6.1 Understanding
sensitivity levels
and modes
6.1.1 Adjusting sensitivity
levels
F 002 DG9 H12
|
2021-04-08