GE PFSS6SMXESS Manuel Du Propriétaire Et Instructions D’installation page 29

Installation Instructions
[] REPLACING THE REFRIGERATOR DOORS
(cont.)
rD-] Insert the top hinge pin into the hinge hole on top of the
refrigerator door. Make sure the door is aligned with the
cabinet and opposite door.Attach the hinge to the top
of the cabinet. Do not tighten bolts completelg.
1,
[] On left-hand doors, pass the wires and water line
through the top hinge pin.Then connect the water line
and door electrical connector.
\
FF1 Attach the ground wire with a Phillips-headscrewdriver
at the right and left hinge.
[] Make sure the gasket on the door is flush against
the cabinet and is not folded. Make sure the door is
straight and the gap between the doors iseven across
the front. While holding the aligned door in place,
tighten the top hinge bolts.
rill Reconnect all connectors at the left and right sides of
the top cap. Reattach the three Phillips-headscrews
on top.
Ground
Wire
[] REMOVE THE FREEZER DOOR
_'1 Pullthe freezer door open to full extension.
[] Removethe freezer bin bg pulling both brackets upward
at the same time. (Seepage 19.)
Fc1 Take out the lower basket bg lifting the basket up from
the rail sgstem.(Seepage 19.)
[] Removethe two 10 mm hex-head bolts from the right
and left side.
29