Inspection And Maintenance Plan; Disposal; Troubleshooting - HOLZMANN MASCHINEN SHT150XF Mode D'emploi

19.1.1 Inspection and Maintenance Plan

Type and degree of machine wear depend on the operating conditions. The following intervals
apply when using the machine within the specified limits:
Interval Component
Table
Daily or
Hydraulic system
before every
Breaks, castors
start of work
Screws, bolts
Monthly Moving parts
Hydraulic oil
Hydraulic unit
Annually
Hydraulic cylinder
Expert inspection
As required Hydraulic lines
20

DISPOSAL

Never dispose of the machine, machine components or equipment in residual
waste. Observe the national disposal regulations. In certain countries retailers
are obliged to dispose of your old machine properly, when you buy a new one.
In doubt, contact your local authorities for information on the possibilities of
legally compliant disposal.
21

TROUBLESHOOTING

The following hazards may occur when working on the hydraulics:
 uncontrolled discharge of the hydraulic fluid
 accidental machine movements
 flying away or bursting parts
 skin diseases
Work on the hydraulics must therefore only be carried out by competent persons with
the appropriate specialist knowledge.
Danger of crushing! Unload the table before carrying out any maintenance work.
During servicing or maintenance work on the hydraulics, there is a risk that the table
will lower from the set position. Before carrying out any maintenance or repair work
in the raised position, support the table securely!
HOLZMANN MASCHINEN GmbH
What to do?
Check for damage
Check for leakage
Check for correct functioning
Check for tight fit
Oil/lubricate all moving parts monthly. Lubrication points: Cylinder
seat (oil); friction surfaces of the rollers (grease); hinge pins (oil);
pedal suspension point (oil); grease nipple (grease).
Change the hydraulic oil (pump out used hydraulic fluid, fill in new
hydraulic fluid).
Check hydraulic unit for leaks. A lifted load must not show any
discernible change in position after 10 minutes (max. 5 mm).
Bleed hydraulic cylinder.
If necessary, have an expert inspection carried out by an authorised
body.
Replace damaged hydraulic lines immediately.
HINWEIS
Hydraulic oils are toxic and must not be released into the environment.
When changing, use suitable collecting containers with sufficient volume!
Follow the manufacturer's instructions and, if necessary, contact your
local authority for further information on proper disposal.
WARNING
WARNING
www.holzmann-maschinen.at
DISPOSAL
SHT150XF | SHT300XF | SHT350XXF
25