Hitachi RAS-25SX8 Manuel De Maintenance page 6

(6) Use a three wire type soldering iron including a grounding wire.
Bare copper wire (for body earth)
Use a high insulation mode (100V, 10M Ω or higher) when ordinary iron is to be used.
(7) In checking circuits for maintenance, inspection, or some others, be careful not to have the test probes
of the measuring instrument shortcircuit a load circuit or the like.
Downloaded from www.Manualslib.com
Metal plate (of Al. stainless steel, etc.)
Fig.3 Grounding of the working table
soldering iron
Screw stop at the screwed
part using a rag plate
Fig.4 Grounding a solder iron
manuals search engine
Staple
– 4 –
Working table
Resistor 1MΩ(1/2W)
Earth wirte
Grounding wire