GM 22890222 Instructions D’installation page 3

4. Slide inner clamp (1) into clamp outer (2).
5. Rotate latch pivot (1) onto clamp outer. Tighten the clamp by
rotating the latch pivot (1) toward the side rail (2).
Soft Rollup Tonneau Cover Package
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
AUTH
REVISION
6. Verify that there is no gap between the rubber clamp pad (1)
and the side rail.
NOTE: If the truck box is equipped with molded bed rail
protector, use the top notch on inner clamp.
COVER TO SIDE RAIL INSTALLATION
1. Place cover assembly (1) into front pivot mount in the side rail
(2). Engage the cover assembly latch (3) into slot on side rail.
NOTE: )LW FRYHU DVVHPEO\ ÀXVK DJDLQVW VLGH UDLO   WKHUH
should be no gap (5).
PART NO.
REV 22JA13
INSTALLATION INSTRUCTIONS
DR
TITLE
Soft Rollup Tonneau Cover Package
PART NO.
22890222
22890222
SHEET
3
SHEET
3 21
OF
21
OF