DOOR DECAL - Bodyside Oval
2009 Chevrolet Corvette Competition Sport
Contents:
Description
Decal - Bodyside "Oval"
Instruction Sheet
Alcohol Wipes
Plastic Squeegee
Tools Required
Lint-free cloth
Spray bottle that contains a mixture of 2 drops of liquid dishsoap
with 20 oz. of water.
Needle
Surface Preparation:
1. The body surface should be between 70°F and 100°F.
2. The surface should be thoroughly washed with warm soap
and water.
3. The surface should be cleaned with the alcohol wipe, followed
by a dry wipe.
Body Feature
Decal - Door
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
03SE09 Initial Release - Wayne Freeman
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GMSPO SPECIFICATIONS.
Quantity
2
1
1
1
Mirror LH
Line
REVISION
Left Hand (LH) Decal Application Instructions:
1. Prepare the surface as indicated above.
2. Place the decal face-down on a flat surface and slowly re-
move the release liner.
3. Using the wetting agent, set the nozzle for fine mist and thor-
oughly saturate the exposed adhesive side of the stripe with
the soap/water mixture (this will allow for repositioning).
4. Use the wetting agent to saturate the body panel with the
soap/water mixture.
5. Align the horizontal edge (A) of the carrier paper of the de-
cal to the door panel feature line and visually align the notch
marked "LH" (B) to the rear of the Driver's side mirror stan-
chion.
6. Saturate the surface paper of the decal to improve conform-
ability to the door panel.
7. Using the plastic squeegee, press the decal into place begin-
ning at the center of the decal while working toward the ends
of the stripe.
8. Carefully remove the top paper carrier at 180 degrees to the
surface of the vehicle.
9. Inspect the decal for imperfections, bubbles and/or poor adhe-
sion along the edges. If necessary, re-press the decal into
place and remove any bubbles with a pin or needle.
10. Avoid power-washing the decal until after 72 hours has
elapsed.
Right Hand (RH) Decal Application Instructions:
1. Follow the same steps as indicated above, but visually align
the notch marked "RH" (C) to the rear of the passenger side
mirror Stanchion.
(For RH side)
IR 03SE09
INSTALLATION INSTRUCTIONS
AUTH
DR
TITLE
1137997
PART NO.
Body Feature Line
20907708
PART NO.
Decal - Door
20907708
1
6
SHEET
OF
1
6
SHEET
OF