Installation; Connection; Eib Configuration - hager TX 450 Manuel D'utilisation

Installation

2

2.1 Connection

• Connect the BCU (2) to the EIB bus by means of EIB
connector (1).
• Screw the mounting plate (2) with the BCU to the hou-
sing.
• Clip the front face (3) to the BCU.
To ensure good visibility, install the Room Controller at a
height of between 1.30m and 1.50m.
2
1
60

2.2 EIB configuration

The Room Controller may be configured by:
➜
ETS : TX 450 application software.
3
• Carry out the EIB configuration of the Room
• Next, configure the front face.
➜
TX 100 : see detailed descrip-
Controller first using the TX100 or the ETS soft-
ware.
61
tion in the instructions
delivered with the
Tebis configuration
tool.
hager