Triggering/Stopping The Cleaning Flush (Mains Version Only); Battery And Battery Replacement - Duravit Wd5007013000 Instructions De Fonctionnement

Triggering/stopping the cleaning flush (mains version only)

You can trigger/stop a flush with a preset flushing duration of 10 seconds in order to
completely rinse out the cleaning agent.
> Press the "Cleaning flush" preselection button on your remote control.
A flush is triggered/stopped.
If you do not stop the flushing operation, the system automatically returns to normal
mode after completing the flush.

7. Battery and battery replacement

WARNING
Contact with electricity can lead to an electric shock.
> Do NOT use the product if it is not working properly or the cables are damaged.
Disconnect the power supply immediately. Contact help@duravit.com.
> Remove the battery module from the actuator plate BEFORE you change the battery.
3
2
1
Disconnecting the cables and removing
the battery module
> Remove the actuator plate (see 6.1 Re-
moving the actuator plate).
> Disconnect the cables connected to the
actuator plate.
> Set the plate aside.
> Release and remove the battery module.
49