Caring For The Blender; Cleaning Instructions - Hamilton Beach Commercial 908 Série Manuel D'utilisation

Caring for the Blender

Cleaning Instructions

wWARNING
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fi re, or electrical shock.
General Cleaning
Do not allow food residue to dry on any part of
the blender. Wash and rinse container, cutter unit
assembly, and base after each use, or whenever
it will not be used again within 1 hour, as follows:
1. Remove the container from the base, and then
remove the cover. Add cleaning solution to the
container. Use a washing solution of hot water
(less than 115°F/46°C) and a nonsudsing
detergent. Use the recommended amount of
detergent.
2. Scrub and fl ush out the container interior,
cover, and fi ller cap to remove food residue.
Empty container.
3. Fill container 1/4 full with fresh washing solution
and place it on the base.
4. Replace the cover on the container and run
the blender on HIGH (2) speed for 2 minutes.
5. Repeat Step 3 using clean rinse water
(95°F/35°C).
6. Wipe down the container, fi ller cap, and cover
with a soft cloth or sponge, dampened with
fresh washing solution.
7. Wipe the exterior of the base with a damp
cloth or sponge. The base contains electrical
components; do not immerse. Do not use a
high-pressure washer or use a dishwasher to
clean the base.
wWARNING
Cut Hazard
Always place cover on container when
blending.
Do not put hands, spoons, or other utensils
in container when blending.
Failure to follow these instructions can
result in broken bones, cuts, or other
injuries.
Sanitizing
1. Wash container as instructed in "General
cleaning."
2. Fill container with sanitizing solution (See
"Recommended Sanitizing Solution" below)
and place on base.
3. Replace cover and fi ller cap and run on LOW (1)
speed for 2 minutes. Empty container.
4. Wipe the container exterior with a soft cloth or
sponge dampened with sanitizing solution.
5. Immerse the cover and fi ller cap in sanitizing
solution for 2 minutes.
6. Remove any remaining moisture from cutter
assembly by placing empty container on base
and running on HIGH (2) speed for 2 seconds.
7. When ready to use, rinse with clean water.
NOTE: Do not rinse container, cover, or fi ller cap
after sanitizing.
Recommended Sanitizing Solution:
The sanitizing solution should consist of 1
Tablespoon (15 ml) of household bleach per 1
gallon of clean, cool water (60°F/16°C) mixed
according to the instructions on the bleach
container. When using a sanitizing solution other
than that recommended, the sanitizing solution
concentration should be tested using commercially
available test strips and should indicate a
concentration between 100 and 200 parts per
million of bleach to water.
7