Professional Blending Techniques - Hamilton Beach Commercial 908 Série Manuel D'utilisation

Operation

Professional Blending Techniques

Filling the Container
When fi lling the container with ingredients, follow
these recommendations:
• Use suffi cient amount of liquid to ensure that the
mixture is fl uid and free-running at all times. Pour
the liquid into the container FIRST.
• Cut solid ingredients into pieces that are no
bigger than a 1ʺ (25-mm) cube.
• Add the ingredients to container in batches. Do
not blend maximum volume all at once.
• Do NOT overfi ll the container with product. This
may prevent the blender from processing the
product properly. Process dense foods or thick
mixtures in small batches, and remember that
the volume of the product normally increases
during processing.
• Do not exceed 1 quart (1 liter) of content when
blending hot product.
• Always place the cover and fi ller cap on the
container when blending. For blending hot
liquids, remove fi ller cap from container cover
before blending.
Blending Techniques
Icy drinks – Do not use blender to crush large ice
cubes. The blender is not designed for this. Small
ice cubes or crushed ice is recommended. Pour in
liquid; then add ice. Cover. Set speed at HIGH (2)
and process until desired consistency is reached.
Chunks of frozen fruit can be added to milk or
fruit juice to produce a sherbet or slush.
6
wWARNING
Burn Hazard
Always use caution when blending hot
contents.
Failure to follow these instructions can
result in burns.
Blending Hot Mixtures
w WARNING Burn Hazard: To minimize the
possibility of scalding, the following precautions
MUST be observed:
• Do not exceed 1 quart (1 L) of content when
blending hot product. Remember that the
volume of the product normally increases during
processing.
• Always place the cover on the container and
remove the fi ller cap from container cover when
blending hot liquids to prevent the buildup of
pressure.
• Never stand with your face directly over the
container when operating the blender where
steam may be released.
• Begin on LOW (1) speed and then select a
speed that produces a column of air in the
center of the container.
Filler Cap
Use the fi ller cap to add liquids to the container
while the unit is running.