Adjusting The Functions; Holiday Mode - Conrad BASETech 1517164 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

b) Adjusting the functions
Press and hold the "SET" button for 3 seconds to set the function. Select "St" for the function setting
and confirm your selection with the "SET" button.
• Press the "SELECT" button to toggle between holiday mode "Ho" and the heat/cool mode "Ht" or
"CL" . Confirm your setting with the "SET" button.
Holiday mode

Holiday mode

This function maintains the desired temperature consistent for one to 199 days. Use the " " and
" " to increase or decrease the days. Press the "OK" button to confirm your settings. The count-
down that runs counts the set number of days down to 0.
When the device is in the holiday mode, the set temperature is maintained while in this
mode. Program settings are only obtained when the countdown of the holiday mode is at
0 or the Holiday Mode is reset to 0!
Heat/Cool control
The device can be used as a two-point controller for cooling or heating systems. When in heat
mode, the device switches off as soon as the target temperature is exceeded and in cool mode
as soon as the target temperature is undercut. When active, the operating mode is indicated by
a flame or snowflake. Also a delay of 5 minutes can be set. This causes a switching hysteresis
that protects the connected systems from rapidly changing between ON (NO) and OFF (NC).
Heat/cool mode
31

Publicité

Table des Matières
loading

Table des Matières