AEG KK 30 Instructions D’utilisation page 33

•
ECO
The device is in energy saving mode.
The "ON" LED (6) lights up green.
1. Press the "SET" key (5) twice.
The current operating mode will
flash in the display (8).
2. Use the "UP" (9) or "DOWN" (10)
key to select the desired setting.
The display (8) will automatically apply
the setting after a few seconds.
TROUBLESHOOTING
Problem
The device is not working.
The LED doesn't light up.
The device does not cool.
The LED is on.
The device does not cool.
The display shows error
code "E1".
Tips for achieving the best cooling
power
•
Select a well ventilated location for
use, away from sunlight.
•
allow warm dishes to first cool down
before keeping them cool in the cool
box.
•
Do not open the cool box more than
necessary.
•
Do not leave the cool box open
longer than necessary.
•
Defrost the cool box if ice has built
up.
•
Do not set the temperature lower
than necessary.
Possible cause
No power from the car
power socket.
The fuse has blown.
Compressor defective.
Input voltage too low.
Battery monitor set too high.
English
Correction
The 12 V/24 V power socket
of the vehicle may not be on
until the ignition has been
turned.
Replace the fuse.
Have the device repaired by
an authorised service centre.
Check the battery voltage.
Change the battery monitor
setting.
33