Troubleshooting - AEG IKK86683FB Notice D'utilisation

22 www.aeg.com
Cooker hoods with the Hob²Hood
function
To find the full range of cooker hoods
which work with this function refer to our

9. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
9.1 What to do if...
Problem
You cannot activate or op‐
erate the hob.
You cannot select the
maximum heat setting for
one of the cooking zones.
You cannot activate one of
the cooking zones.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
The hob deactivates.
Residual heat indicator
does not come on.
consumer website. The AEG cooker
hoods that work with this function must
have the symbol
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is blown.
You do not set the heat set‐
ting for 10 seconds.
You touched 2 or more sen‐
sor fields at the same time.
Pause operates.
There is water or fat stains
on the control panel.
The other zones consume
the maximum available pow‐
er.
Your hob works properly.
You put something on one or
more sensor fields.
You put something on the
control panel.
The zone is not hot because
it operated only for a short
time or the sensor is dam‐
aged.
.
Remedy
Check if the hob is correctly
connected to the electrical
supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Activate the hob again and set
the heat setting in less than 10
seconds.
Touch only one sensor field.
Refer to "Additional functions".
Clean the control panel.
Reduce the heat setting of the
other cooking zones connec‐
ted to the same phase. Refer
to "Power management".
Remove the object from the
sensor fields.
Remove the object from the
control panel.
If the zone operated sufficient‐
ly long to be hot, speak to an
Authorised Service Centre.