Installing The Tow Bar As A Handlebar (Wagon Mode); Removing The Handlebar; Lowering The Caster Wheels; Installing The Cover - Burley Hopper Manuel D’instructions Et De Sécurité Du Propriétaire

Installing the Tow Bar as a Handlebar (Wagon Mode)

1
While aligning the hook with the top of the trailer
frame , insert the towbar into the handlebar
A
receiver until it clicks into place.
b
Lowering the Caster Wheels (Wagon Mode)
1
Press button to release
each caster.
HoPPEr
A
B
Ensure that the handlbar is locked to the frame.
the red indictor on the towbar hook should not
be visible when the handlebar is fully seated.
2
Lower each caster wheel
until it locks into place.
ENG
2

Installing the Cover

1
Install the cover by wrapping the elastic
edges over the upper frame tubing.
DEU FRA ESP

Removing the Handlebar

1
Press the release button
and lift to remove.
2
Secure the G-hooks to the webbing at the
front and rear of the Hopper and tighten
the cinch cord to secure the cover.
ASSEMBLY & uSE
11