Britax ReboundReduce POPLAR Installation Et Dépose

Tools required:
• No tools needed
Removing the ReboundReduce
Stability Bar
1. Open the ClickTight.
a. Lift the front cover flap (Fig 1).
b. Squeeze the ClickTight release buttons
(Fig 1).
2. Push the stability bar release button and
pull the stability bar away on one side.
Repeat on the other side (Fig 2).
3. Close the ClickTight.
Installing the ReboundReduce
Stability Bar
1. Open the ClickTight.
a. Lift the front cover flap (Fig 3).
b. Squeeze the ClickTight release buttons
(Fig 3).
2. Insert the stability bar into the two
openings at the front of the seat (Fig 4).
3. Ensure the stability bar release buttons are
completely engaged (Fig 5).
4. Pull the stability bar away from child
restraint on both sides to confirm
connections (Fig 6).
Page 1 of 3
P14764600_A.3:04.24
P14764600_A-3_INST-SHEET_ARB_POPLAR.indb 1 P14764600_A-3_INST-SHEET_ARB_POPLAR.indb 1
POPLAR
Removing / Installing the
ReboundReduce
Instructions
Kit includes:
ReboundReduce
Stability Bar
TM
b
Fig. 1
TM
b
Fig. 3
Fig. 5
Poplar , ReboundReduce and Britax® are trademarks owned by Britax Child Safety, Inc. All rights
TM TM
reserved. ©2024 Britax Child Safety, Inc. This product and its components are subject to change
without notice. Printed in China. Britax Child Safety, Inc., 4140 Pleasant Road, Fort Mill, SC 29708, U.S.A.
Consumer Services: 888.427.4829 or 704.409.1699 www.Britax.com
CAR SEAT
TM
Stability Bar
TM
TM
a
Fig. 2
a
Fig. 4
Fig. 6
4/19/24 10:05 AM 4/19/24 10:05 AM