Air Conditioner Use; Starting Your Air Conditioner - Amana Acw106R Guide D'utilisation Et D'entretien

Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■ If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This keeps the air conditioner from
blowing a fuse or tripping a circuit breaker.
■ Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 66°F (19°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
Models Without Heat
Models With Heat
1. Remove clear plastic film from control panel.
2. Press POWER to turn on air conditioner.
NOTE: When the air conditioner is turned on, it will display
the previous settings for the mode, fan speed and
temperature.
3. Choose mode. See "Mode."
4. Choose fan speed. See "Fan Speed."
5. Choose temperature. See "Temperature."

AIR CONDITIONER USE

NOTES:
■
■

Starting Your Air Conditioner

The Exhaust Air feature allows the air conditioner to either
recirculate inside air (CLOSED) or exhaust air to the outside
(OPEN).
■
■
NOTE: The OPEN or CLOSED position can be used with any
mode selection.
1. Press MODE until you see the indicator light come on for the
2. Choose Cool, Heat (on some models), Fan Only or Power
In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
If the electronic control will not respond to touch pad or
remote control commands, it is necessary to unplug the air
conditioner from the electrical outlet for 5 seconds before
plugging back in.
Display Symbols
A
B
G
F
A. Cool mode indicator light
B. Fan only mode indicator light
C. Heat indicator light
(on some models)
D. Power Saver indicator light
Exhaust Air
CLOSED—used when maximum cooling is desired. It may
also be used for air recirculation without cooling when the air
conditioner is set to Fan mode.
OPEN—removes stale air from the room and exhausts it to
the outside.
Mode
setting you desire.
Saver.
■ Cool—Cools room. Press FAN SPEED to choose fan
speed. Then adjust the temperature by pressing the plus
or minus buttons.
■ Heat (on some models)—The air conditioner will circulate
and heat the air.
When heater is powered off, Low fan speed will
automatically stay on and run for 30 seconds.
■ Fan Only—Operates the fan at Low, Mid or High speed,
without cooling. Display will show the current room
temperature.
C D
E
H I
E. Timer indicator light
F. Auto fan mode indicator light
G. Low fan mode indicator light
H. Mid fan mode indicator light
I. High fan mode indicator light
9