Husqvarna 330LK Manuel D'utilisation page 15

To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass.
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. Use full speed.
To sweep the grass
The airflow from the rotating trimmer line can be
used to remove cut grass from an area.
1. Hold the trimmer head and the trimmer line
parallel to the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and
sweep the grass.
WARNING:
cover each time you assemble new
trimmer line to prevent unbalance and
vibrations in the handles. Also do a
check of the other parts of the trimmer
head and clean it if necessary.
1660 - 003 - 29.09.2021
Clean the trimmer head
To extend the trimmer line
• When the trimmer line becomes short during
operation, tap the trimmer head on a hard, flat
surface to extend more trimmer line. You must
operate the product at full speed to get the best
result.
To replace the trimmer line
1. Hold the lower half (A) of the trimmer head with
one hand. Use your opposite hand to turn the top
half (B) of the trimmer head.
A
a) For straight shaft grass trimmers, turn the top
half of the trimmer head clockwise.
b) For curved shaft grass trimmers, turn the top
half of the trimmer head counterclockwise.
Note:
It is not necessary to push the top
half of the trimmer head down when you turn
it.
Note:
When you turn the top half of the
trimmer head, you will hear a click.
2. Continue to turn the top half of the trimmer head
until the triangle (C) aligns with the hole (D).
3. Remove and discard the remaining trimmer line.
B
C
D
15