Fault Detection - Create Studio Crystal Mist Mode D'emploi

• When the fryer is in use and a fault is detected, the fryer will stop working, sound a beep,
and enter fault mode. The fault code will be displayed on the screen, all program lights will
turn off and the buttons will not work.
• When the screen is off, if any fault is detected, it will not be reported.
Error message E1.
• After starting the heating work for 1 minute, the open circuit of the temperature sensor is
detected for 3 seconds continuously (the temperature is lower than -20ºC), all lights will
go out, and an alarm will be issued at the same time.
• The display will show the error message E1, the error beep will sound 10 times, and the
fryer will enter fault mode.
• Turn the fryer back on to see if the error persists. If so, contact customer service.
Error message E2.
• If a short circuit in the appliance's temperature sensor (temperature above 260°C)
is detected for 3 consecutive seconds, the fryer will shut down and the alarm will be
activated at the same time.
• The display will show error code E2, the alarm sound will continue to sound, and the fryer
will enter fault mode.
• Turn the fryer back on to see if the error persists. If so, contact customer service.
Error message C4
• If the fryer basket is not detected for 5 consecutive seconds, the fryer will shut off and an
alarm will sound.
• The display will show error code C4, and a beep will sound once, indicating that there is
no basket in the fryer.
• Place the basket inside the fryer.
• If you do not place the basket inside the fryer after 10 minutes, the fryer will enter
standby mode and the display will turn off.
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous
substances in electric and electronic equipment as well as their waste disposal. The symbol with the
crossed dustbin shown on the package indicates that the product at the end of its service life shall be
collected as separate waste. Therefore, any products that have reached the end of their useful life must
be given to waste disposal centres specialising in separate collection of waste electrical and electronic
equipment, or given back to the retailer at the time of purchasing new similar equipment, on a one for one
basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible nega-
tive effects on the environment and health and optimises the recycling and reuse of components making
up the apparatus. Abusive disposal of the product by the user involves application of the administrative
sanctions according to the laws.

FAULT DETECTION

E NGLI SH
13